Home > Neway Mfg. Valve and Seat Carbide Cutters >

Neway PM100-4.00 mm Small Series Solid Valve Guide Pilot | Top Diameter .297
Neway Small 100 Series Solid Pilot


 
Alternative Views:


Custom sizes not listed are available upon request. Please allow 7-10 days before shipment.
Our Price: $19.25

Quantity in Stock:2
Availability:: Usually Ships in 24 Hours
Product Code: NEWPM10040
Qty:

Description Technical Specs
 
Solid pilot for Neway smaller 100 series cutter heads. Pilot measures.297 on top or cutter side of pilot.

  • Center Portion of Taper (Middle) - 0.1575" (4mm)
  • Widest Portion of Taper (Top) -- 0.1585" (4.03mm)
  • Bottom Portion of Taper Length - 2 1/4" Long
  • Top Portion of Pilot Shaft (Cutter Portion): .297 Diameter - 2 1/4" Long
  • Center-less ground for extremely tight tolerances.
  • Made in USA

Features
  • The following information is from Neway Manufacturing Website Technical Recommendations:

  • The pilot is absolutely critical to getting a concentric valve seat. It “pilots” the cutter by indicating off the same bearing surfaces that the valve stem will be riding on, and carrying that center-line up to the cutter. If the pilot is not straight and concentric, the cutter cannot form a concentric seat. Neway pilots are center-less ground, a process that enables us to hold extremely tight tolerances.


  • Solid pilots have a very slight taper ground into them, so that they lock into the valve guide. The rate of taper is just .0007” per inch (7 microns/cm). This very slight taper means that the pilot will be hanging onto enough of the length of the guide bore to accurately capture the center-line. The flip side of having such a slight amount of taper is that a single pilot can only accommodate a small amount of variance between guide bore sizes, so you will usually require more than one solid pilot for any given nominal size.

Share your knowledge of this product. Be the first to write a review »